KNX Cyclic Send

This function block sends a value cyclically to the KNX bus. This can be used, for example, for a monitoring function (heartbeat).

Inputs
FG	Enable	Enable. At 1 the value is sent cyclically. This input is optional; if nothing is linked to the input, the block is enabled automatically.
TM	Time	Time interval for the cyclic sending in seconds. This input is optional; if nothing is linked to the input, it is sent every 5 seconds. The minimum time is 1 second.
SW	Setpoint	Value that is sent cyclically.
Outputs
A1	Address	Address. An address from the KNX range must be linked to the output.
TM	Remaining time	Remaining time in seconds until the next send.
Parameters
	Apply changes	If this parameter is activated, a change of the value at input SW is sent immediately and the cycle time is restarted. Default: activated.

Inputs